Komatsu · Engine controller
Komatsu Fault Code B@BAZG
Engine oil pressure low
What does Komatsu code B@BAZG mean?
The engine oil pressure is below the allowed value for the speed. Running on may destroy the bearings, so stop the engine. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level and filter condition.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Stop the engine and check the oil level and filter condition
Then 4 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 5 done
Causes
- Low engine oil level
- Worn oil pump or bearings
- Clogged oil filter
- Failed oil pressure switch or wiring
How it failed
You'll notice: Oil pressure warning on the monitor with B@BAZG; stop the engine.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine fluid, filter and temperature warnings
- B@BAZGEngine oil pressure lowOtherStop now
- B@BAZKEngine oil level lowOtherCheck soon
- B@BCNSEngine coolant overheatingShorted highStop now
- B@BCZKEngine coolant level lowLost messageCheck soon
- B@HANSHydraulic oil overheatingShorted highStop now
- AA10NXAir filter cloggedReal conditionCheck soon
- CA428Water in fuel sensor: high voltageShorted highCheck soon
- CA429Water in fuel sensor: low voltageShorted lowCheck soon
- CA435Engine oil pressure switch errorOtherCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)
This source lists B@BAZG and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
