EF Logo

John Deere · Monitor controller (DSZ) - alarms

John Deere Fault Code DSZ 20110.02

Fuel filter restriction alarm

What does John Deere code DSZ 20110.02 mean?

The fuel filter looks restricted, so the fuel supply may not keep up under load. Diagnose ECU code 000094.17 per the engine manual. Urgency: check soon - the machine may derate or limit a function. Check first: replace the fuel filter and bleed the system following the engine manual.

FaultCheckDSZ20110.02John Deere · Monitor controller (DSZ) - alarms
DSZ
Which controller reports it
20110
What is at fault
.02
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Replace the fuel filter and bleed the system following the engine manual

Then 4 more checks
Code shows hereFAULTDSZ20110.02

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Fuel filter blocked
  • Fuel supply line kinked
  • Fuel pressure sensor faulty
  • Contaminated fuel

How it failed

You'll notice: The fuel filter looks restricted.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine, overheat, fuel and water alarms on the monitor

8 other codes on this part are also real condition (DSZ 20100.02, ICZ 20110.02, DSZ 20114.02, ICZ 20114.02 and more). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Engine, overheat, fuel and water alarms on the monitor codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists DSZ 20110.02 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.