EF Logo

JLG · Electrical

JLG Fault Code 445

Battery voltage low (warning)

What does JLG code 445 mean?

Battery voltage is below about 11 V for over 5 seconds, not counting cranking. The controller keeps running but it is warning that the battery is weak. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage at rest and with the engine running.

FaultCheck445JLG · Electrical

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage at rest and with the engine running

Then 4 more checks
Code shows hereFAULT445

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Weak or old battery that will not hold charge
  • Alternator undercharging because of a slipping belt or bad output
  • Loose or corroded terminals dropping voltage under load
  • Large load left on, such as lights or accessories

How it failed

You'll notice: A low battery warning shows but the machine keeps running, with the voltage under about 11 V for more than 5 seconds.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery, contactors, starting, generator, lights and alarm outputs

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 445 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.