JLG · Platform / ground controls
JLG Fault Code 2‑5
Function prevented by cutout
What does JLG code 2-5 mean?
Not a failure. The controller blocks a function on purpose because a cutout is set: drive while elevated, boom while driving, or drive while tilted and above elevation. Urgency: information - a reminder or status message. Check first: read the Help message: DRIVE PREVENTED or BOOM PREVENTED.
Can I keep running with it?
Information
A reminder or status message. Nothing is failing yet.
What should I check first?
Read the Help message: DRIVE PREVENTED or BOOM PREVENTED
Then 3 more checksWhere this code shows
Turn the key on and watch the fault lamp or platform display.
Checks
0 of 4 done
Causes
- Drive selected while the boom is above elevation with drive cutout configured
- Boom function selected while driving with the no-simultaneous-drive cutout active
- Chassis tilted past the set angle while above elevation
- Function cutout configuration digit set for CE or a special market
How it failed
You'll notice: A function refuses to move on purpose and the lamp shows 2-5.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Cutouts, reduced speed, overload and status messages
- 001Everything OKOtherInformation
- 2-5Function prevented by cutoutOtherInformation
- 0010Running at cutback - out of transport positionOtherInformation
- 0012Running at creep - creep switch openOtherInformation
- 0013Running at creep - tilted and above elevationOtherInformation
- 0030Running at creep - platform stowedOtherInformation
- 211Power cycleOtherInformation
- 259Model changed - hydraulics suspended - cycle EMSOtherInformation
- 681Remote contract management override - all functions in creepOtherInformation
Show the other 8 codesHide the other codes
- 826Running at creep - platform overloadedReal conditionCheck soon
- 827Drive & boom prevented - platform overloadedReal conditionCheck soon
- 828Lift up & tele out prevented - platform overloadedLost messageCheck soon
- 2513Generator motion cutout activeOtherInformation
- 2514Boom prevented - drive selectedReal conditionInformation
- 2516Drive prevented - above elevationReal conditionInformation
- 2517Drive prevented - tilted & above elevationReal conditionInformation
- 2518Drive prevented - boom selectedReal conditionInformation
Other JLG codes: Platform / ground controls
Related on Equipments Finder
Source
JLG 600S/600SJ/660SJ/600A/AJ Service and Maintenance Manual 3120840, section 6 (Tables 6-3, 6-5)
This source lists 2-5 and its meaning. The guidance on this page is general, not taken from it.
The source covers: JLG boom lifts with the JLG Control System (600S, 600SJ, 660SJ, 600A/AJ, 450A, 510A, 400S, 1200/1350SJP families).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
