EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4375 Fault Code

Aftertreatment diesel exhaust fluid pump drive percentage

What does SPN 4375 mean?

How hard the ECM is driving the DEF pump (percent output). It is used to spot a pump that is working harder than normal for the pressure it reaches. How urgent it is depends on the FMI after SPN 4375 - pick it below. Check first: run the DEF pump prime test and read the commanded and actual pump drive in the service tool.

FaultActiveSPN 4375FMI --J1939 engine ECU
SPN 4375
Aftertreatment diesel exhaust fluid pump drive percentage
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4375 - pick it below.

What should I check first?

Run the DEF pump prime test and read the commanded and actual pump drive in the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4375?

You'll notice: The DEF pump drive circuit is faulty, so the pump may not run or may run flat out.

Find the number shown after SPN 4375 on your display.

  • 0SPN 4375 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
  • 1SPN 4375 FMI 1: Value is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
  • 3SPN 4375 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
  • 4SPN 4375 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
  • 5SPN 4375 FMI 5: Current is below normal, or the circuit is openOpen circuitDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
  • 6SPN 4375 FMI 6: DEF pump supply current is highShorted lowDetroit DD15
  • 12SPN 4375 FMI 12: Bad intelligent device or componentPart or controllerMack MP8, Mack MP7, Volvo D13
  • 14SPN 4375 FMI 14: A special-instruction condition defined by the engine maker appliesOtherMack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4375 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Pump supply or ground open or shorted: blown fuse, corroded plug or a chafed lead at the pump module
  • Pump motor worn out or seized, so it draws too much or too little current
  • DEF filter or line blocked, loading the pump until it trips the drive
  • Pump drive signal from the control module wrong or missing

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list names SPN 4375 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.