EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4374 Fault Code

Aftertreatment diesel exhaust fluid pump motor speed

What does SPN 4374 mean?

Speed of the DEF pump motor in the dosing unit. The control uses it to hold DEF line pressure and to detect pump or line problems. How urgent it is depends on the FMI after SPN 4374 - pick it below. Check first: check the DEF tank level and for ice, then run the pump prime test.

FaultActiveSPN 4374FMI --J1939 engine ECU
SPN 4374
Aftertreatment diesel exhaust fluid pump motor speed
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4374 - pick it below.

What should I check first?

Check the DEF tank level and for ice, then run the pump prime test

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4374?

You'll notice: The DEF pump is running at the wrong speed, so the system cannot hold dosing pressure.

Find the number shown after SPN 4374 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4374 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Pump motor worn, seized or its drive circuit faulty
  • Blocked DEF filter or frozen line making the pump work too hard or run dry
  • Air in the DEF line from a low tank or a leak
  • Pump speed signal or its wiring faulty

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4374 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.