EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4374 FMI 0

DEF system under-pressurized

What does SPN 4374 FMI 0 mean?

DEF system pressure is below target. DEF cannot be dosed correctly, so NOx conversion drops and the engine may derate. Urgency: check soon - the machine may derate or limit a function. Check first: check the DEF level and look for ice, then run the pump prime test.

FaultCheckSPN 4374FMI 0J1939 engine ECU
FMI 0
Data above normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the DEF level and look for ice, then run the pump prime test

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Frozen or empty DEF tank
  • DEF filter blocked, starving the pump
  • DEF pump worn and unable to build pressure
  • Leak in a DEF line letting the pressure bleed off

How it failed

You'll notice: DEF system pressure is below target, so DEF cannot be dosed correctly: NOx conversion drops, the SCR lamp comes on and the engine may derate.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 4374 with FMI 0. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.