J1939 · Aftertreatment - SCR/DEF
SPN 4094 Fault Code
NOx limits exceeded due to insufficient reagent quality
What does SPN 4094 mean?
A status that the ECM sets when NOx stays above limits and the cause is poor DEF quality. It feeds the SCR inducement strategy. How urgent it is depends on the FMI after SPN 4094 - pick it below. Check first: test a sample with a refractometer and compare it with the DEF concentration figure.
- SPN 4094
- NOx limits exceeded due to insufficient reagent quality
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 4094 - pick it below.
What should I check first?
Test a sample with a refractometer and compare it with the DEF concentration figure
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 4094?
You'll notice: The ECM judges that NOx is over its limit because the DEF in the tank is not good enough, and it starts operator inducement.
Find the number shown after SPN 4094 on your display. FMI 31 has its own page with causes and checks.
- 1SPN 4094 FMI 1: Value is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 14SPN 4094 FMI 14: A special-instruction condition defined by the engine maker appliesOtherMack MP8, Mack MP7, Volvo D13
- 18SPN 4094 FMI 18: Value is below the normal range, moderately severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 31SPN 4094 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 4094 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Wrong fluid in the DEF tank, such as water, diesel or a different additive
- DEF diluted with water or broken down by long storage in heat
- Contaminated tank, supply line or pump module after an old or dirty fill
- DEF quality sensor reading wrongly, so good fluid is judged poor
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 4094 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
