EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4094 FMI 31

NOx limits exceeded from poor reagent quality

What does SPN 4094 FMI 31 mean?

The ECM sees NOx above its limit because the DEF quality is too poor. It starts an inducement, so the engine will derate and then limit speed. Urgency: stop now - shut down and fix before working on. Check first: check the receipt or source of the last DEF fill and the cap and breather for damage.

FaultStopSPN 4094FMI 31J1939 engine ECU

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the receipt or source of the last DEF fill and the cap and breather for damage

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Wrong fluid was put in the DEF tank at the last fill
  • Old or heat-damaged DEF that has lost strength
  • Water got into the tank through a damaged cap or breather
  • SCR catalyst damaged by earlier bad DEF, so NOx stays high even with good fluid

How it failed

You'll notice: The ECM sees NOx over its limit and puts the blame on poor reagent quality, so inducement starts.

Real conditionRead from FMI 31: condition exists

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 4094 with FMI 31. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.