EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PSID 22 FMI 3

Counter shaft brake valve shorted high - brake applied

What does Volvo/Mack code MID 130 PSID 22 FMI 3 mean?

The high-side drive of the counter shaft brake solenoid valve is shorted to battery, so the valve and the brake are activated. Urgency: stop now - shut down and fix before working on. Check first: do not drive the truck with the red lamp on before you replace any parts.

FaultStopMID 130PSID 22FMI 3Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PSID 22
Maker component at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Do not drive the truck with the red lamp on before you replace any parts

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • High-side drive shorted to U-BATT
  • Counter shaft brake solenoid valve failure
  • Harness shorted to battery on the transmission

How it failed

You'll notice: The red stop lamp is lit and the transmission will be damaged if the vehicle is driven.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PSID 22 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.