EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PID 33 FMI 2

Clutch position sensor signals disagree

What does Volvo/Mack code MID 130 PID 33 FMI 2 mean?

The two clutch position signals from the clutch cylinder sensor (SEPoC and its inverted partner SEPoCINV) differ too much while both are inside the normal range. The control unit cannot trust the clutch position. Urgency: check soon - the machine may derate or limit a function. Check first: read the two clutch position signals in the scan tool with the clutch moving; they should mirror each other.

FaultCheckMID 130PID 33FMI 2Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PID 33
Parameter at fault
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the two clutch position signals in the scan tool with the clutch moving; they should mirror each other

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Clutch cylinder position sensor failing or drifting
  • Poor connection in the sensor plug at the clutch actuator
  • Damaged wiring between the sensor and the transmission control unit

How it failed

You'll notice: Yellow lamp is sent, the clutch acts slowly, starts feel rough and gear changes are slow, especially at crawl speed.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Clutch position sensor

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PID 33 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.