Volvo/Mack · MID 130 transmission ECU
Volvo/Mack Fault Code MID 130 PSID 200 FMI 9
Lost data link to engine control module (ECM)
What does Volvo/Mack code MID 130 PSID 200 FMI 9 mean?
The transmission control unit is missing messages from the engine control module on the J1939 data link. Urgency: check soon - the machine may derate or limit a function. Check first: check that the engine ECM answers the scan tool; if not, work on its power and ground first.
- MID 130
- Which control unit reports it
- PSID 200
- Maker component at fault
- FMI 9
- Abnormal update rate
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check that the engine ECM answers the scan tool; if not, work on its power and ground first
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Engine control module not sending on the J1939 link
- J1939 CAN harness damaged between the engine and transmission control module
- Connector fault at the TCM or the engine ECM
How it failed
You'll notice: Yellow lamp sent.
Lost messageRead from FMI 9: abnormal update rate
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 130 transmission ECU
- MID 130 PSID 201 FMI 9Lost data link to vehicle ECU
- MID 130 PSID 22 FMI 3Counter shaft brake valve shorted high - brake applied
- MID 130 PSID 25 FMI 11First gear cannot engage
- MID 130 PSID 25 FMI 12Reverse gear cannot engage
- MID 130 PSID 27 FMI 0Clutch disengages unintentionally
- MID 130 PSID 27 FMI 11Clutch drag
- MID 130 PSID 27 FMI 12Clutch slipping
- MID 130 PSID 27 FMI 14Clutch cannot disengage - engine shut down
Related on Equipments Finder
Source
This source lists MID 130 PSID 200 FMI 9 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
