EF Logo

Volvo/Mack · MID 128 engine ECU - fuel, injectors and timing

Volvo/Mack Fault Code MID 128 SID 22 FMI 3

Crankshaft position sensor signal missing

What does Volvo/Mack code MID 128 SID 22 FMI 3 mean?

The crankshaft position signal is missing, from an open, a short to battery or a short to ground in the CKP sensor circuit. The ECM cannot know engine speed or crank angle, which it needs for injection timing. Urgency: stop now - shut down and fix before working on. Check first: look at the crankshaft sensor connector near the flywheel housing for oil, heat and loose pins.

FaultStopMID 128SID 22FMI 3Volvo/Mack · MID 128 engine ECU - fuel, injectors and timing
MID 128
Which control unit reports it
SID 22
Component at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Look at the crankshaft sensor connector near the flywheel housing for oil, heat and loose pins

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Open wire or connector fault on the CKP sensor circuit at the flywheel housing
  • Short to battery or ground in the sensor wiring
  • Failed crankshaft position sensor or a missing tone wheel signal
  • Metal debris on the sensor tip

How it failed

You'll notice: The engine may crank but not start, or it loses power and stalls, with the MIL and yellow lamp lit.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Camshaft and crankshaft position sensors

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 22 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.