EF Logo

Kubota · Engine ECU - SPN / FMI codes

Kubota Fault Code SPN100‑FMI1

Engine oil pressure low

What does Kubota code SPN100-FMI1 mean?

SPN 100 FMI 1 means oil pressure dropped below the safe limit. Continuing to run can destroy the bearings, so stop the engine and find the cause. Urgency: stop now - shut down and fix before working on. Check first: shut the engine down at once and read the dipstick for level, colour and fuel smell.

FaultStopSPN100FMI1Kubota · Engine ECU - SPN / FMI codes
FMI 1
Data below normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Shut the engine down at once and read the dipstick for level, colour and fuel smell

Then 4 more checks
Code shows hereFAULTSPN100FMI1

Where this code shows

Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.

Checks

0 of 5 done

Causes

  • Engine oil level below the pickup tube
  • Oil filter or strainer blocked by sludge
  • Oil thinned by fuel dilution after repeated failed regenerations
  • Worn main or rod bearings leaking oil pressure

How it failed

You'll notice: Oil pressure lamp and buzzer, with the ECU lamp lit; stop the engine at once.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant, intake air temperature, oil pressure and overheat

Source

Kato Works - Kubota engine error codes (SPN / FMI table)

This source lists SPN100-FMI1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Kubota common-rail Tier 4 engines. The source lists the code under Kubota engines without naming machines (these engines power SVL/SSV loaders and KX/U excavators).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.