Kubota · Engine ECU system (E:91xx)
Kubota Fault Code E:9118
Engine oil pressure system error
What does Kubota code E:9118 mean?
The engine oil pressure is low or the sensor circuit reports a fault. Stop the engine if the pressure is really low. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level on the dipstick.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Stop the engine and check the oil level on the dipstick
Then 4 more checksWhere this code shows
Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.
Checks
0 of 5 done
Causes
- Low oil level
- Oil pump or pickup worn or blocked
- Oil pressure sensor failed
- Wiring fault
How it failed
You'll notice: Oil pressure lamp and E:9118 lit; stop the engine at once to avoid damage.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Coolant, intake air temperature, oil pressure and overheat
- SPN172-FMI3Intake air temperature sensor - open circuit or short to batteryShorted highCheck soon
- SPN172-FMI4Intake air temperature sensor - open circuit or short to groundShorted lowCheck soon
- SPN190-FMI0Engine overrunReal conditionStop now
- E:9103Intake air temperature sensor system errorOtherCheck soon
- E:9104Coolant temperature system errorErratic or implausibleCheck soon
- E:9105Fuel temperature sensor system errorOtherCheck soon
- E:9114Pre-overheatReal conditionCheck soon
- E:9116Engine overheat warningShorted highStop now
- E:9118Engine oil pressure system errorOtherStop now
Show the other 6 codesHide the other codes
- SPN100-FMI1Engine oil pressure lowReal conditionStop now
- SPN110-FMI0Engine overheat - coolant temperature extremely highReal conditionStop now
- SPN110-FMI3Coolant temperature sensor - short to batteryShorted highCheck soon
- SPN110-FMI4Coolant temperature sensor - open circuit or short to groundShorted lowCheck soon
- SPN171-FMI3Intake air temperature sensor (built into MAF) - short to batteryShorted highCheck soon
- SPN171-FMI4Intake air temperature sensor (built into MAF) - open circuit or short to groundShorted lowCheck soon
Other Kubota codes: Engine ECU system (E:91xx)
Related on Equipments Finder
Source
This source lists E:9118 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
