Komatsu · Pump controller
Komatsu Fault Code DHPAMA
Front pump pressure sensor abnormal
What does Komatsu code DHPAMA mean?
The front pump pressure sensor signal is outside range or not following the real pump pressure. The pump controller may set pump output wrongly, which can show up as slow or weak working equipment. Urgency: check soon - the machine may derate or limit a function. Check first: check the sensor supply and the DA25KP code first.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the sensor supply and the DA25KP code first
Then 4 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 5 done
Causes
- Front pump pressure sensor connector loose, oily or corroded
- Sensor wire open or shorted
- Failed front pump pressure sensor
- Blocked sensor port
1 more causeFewer causes
- 5 V sensor supply low
How it failed
You'll notice: Working equipment slow or weak with DHPAMA on the monitor.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Pump, PPC, load and oil temperature sensors
1 other code on this part is also lost message (DHPBMA). When they show together, start at the wiring and connector they share.
- DHPAMAFront pump pressure sensor abnormalLost messageCheck soon
- DHPBMARear pump pressure sensor: abnormalLost messageCheck soon
- DHSAMASwing right PPC pressure sensor: abnormalOtherCheck soon
- DHSBMASwing left PPC pressure sensor: abnormalOtherCheck soon
- DHSDMABucket dump PPC pressure sensor: abnormalOtherCheck soon
- DHX1MAOverload (load) sensor (analog): abnormalReal conditionCheck soon
- DGH2KBHydraulic oil temperature sensor short circuitShorted lowCheck soon
- DHS3MAArm-in (bucket arm retraction) PPC pressure sensor: abnormalOtherCheck soon
- DHS4MABucket curl (bucket excavation) PPC pressure sensor: abnormalOtherCheck soon
- DHS8MABoom raise PPC pressure sensor: abnormalOtherCheck soon
Other Komatsu codes: Pump controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists DHPAMA and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
