EF Logo

Bobcat · Hydraulics

Bobcat Fault Code M0515

Hydraulic charge pressure shutdown

What does Bobcat code M0515 mean?

The controller shut the engine down because charge pressure fell below the protection level. Urgency: stop now - shut down and fix before working on. Check first: check the sensor plug and wiring for water; a wet plug can drop the signal low and trip the shutdown.

FaultStopM0515Bobcat · Hydraulics

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the sensor plug and wiring for water; a wet plug can drop the signal low and trip the shutdown

Then 3 more checks
Code shows hereFAULTM0515

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Pressure transducer failing and reading below the real value
  • Leak between the pump and the filter
  • Blocked charge filter
  • Charge pump worn out

How it failed

You'll notice: The controller stopped the engine on very low charge pressure.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Hydraulic charge pressure, workgroup and load sensing pressure

Show the other 18 codes
All 27 Hydraulic charge pressure, workgroup and load sensing pressure codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0515 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders S450-S850 and T450-T870.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.