EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PSID 200 FMI 9

Lost data link to engine control module (ECM)

What does Volvo/Mack code MID 130 PSID 200 FMI 9 mean?

The transmission control unit is missing messages from the engine control module on the J1939 data link. Urgency: check soon - the machine may derate or limit a function. Check first: check that the engine ECM answers the scan tool; if not, work on its power and ground first.

FaultCheckMID 130PSID 200FMI 9Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PSID 200
Maker component at fault
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check that the engine ECM answers the scan tool; if not, work on its power and ground first

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Engine control module not sending on the J1939 link
  • J1939 CAN harness damaged between the engine and transmission control module
  • Connector fault at the TCM or the engine ECM

How it failed

You'll notice: Yellow lamp sent.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PSID 200 FMI 9 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.