Volvo/Mack · MID 128 engine ECU - module, data link and power
Volvo/Mack Fault Code MID 128 PSID 201 FMI 9
Message from instrument cluster missing
What does Volvo/Mack code MID 128 PSID 201 FMI 9 mean?
The engine ECM did not receive an expected message from the instrument cluster or vehicle ECU. The data link harness is the usual suspect. Urgency: check soon - the machine may derate or limit a function. Check first: check communication with the cluster in the scan tool.
- MID 128
- Which control unit reports it
- PSID 201
- Maker component at fault
- FMI 9
- Abnormal update rate
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check communication with the cluster in the scan tool
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Faulty data link harness
- Instrument cluster not communicating
- Connector fault
How it failed
You'll notice: MIL on and some cluster-based functions may be affected while the engine ECM waits for the message.
Lost messageRead from FMI 9: abnormal update rate
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 128 engine ECU - module, data link and power
- MID 128 SID 39 FMI 3Starter relay output shorted high
- MID 128 SID 39 FMI 5Starter relay circuit open
- MID 128 PID 158 FMI 1ECM battery voltage too low
- MID 128 PID 158 FMI 3ECM battery voltage too high
- MID 128 PSID 161 FMI 2Vehicle identification number (VIN) missing
- MID 128 PSID 229 FMI 2SAE J1939 data link 2 circuit shorted or open
- MID 128 PSID 229 FMI 9SAE J1939 data link 2 - lost communication with aftertreatment module
- MID 128 SID 231 FMI 2SAE J1939 data link (CAN 1) circuit fault
Related on Equipments Finder
Source
This source lists MID 128 PSID 201 FMI 9 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
