Volvo/Mack · MID 128 engine ECU - module, data link and power
Volvo/Mack Fault Code MID 128 PSID 161 FMI 2
Vehicle identification number (VIN) missing
What does Volvo/Mack code MID 128 PSID 161 FMI 2 mean?
The engine ECM could not get a VIN answer from the other modules. This happens when a module has been replaced and no VIN was loaded, or the data link is down. Urgency: stop now - shut down and fix before working on. Check first: check the VIN stored in each module in the scan tool.
- MID 128
- Which control unit reports it
- PSID 161
- Maker component at fault
- FMI 2
- Erratic or incorrect data
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check the VIN stored in each module in the scan tool
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- VIN missing in other ECMs, commonly the VECU or light control module
- Data link error
- Engine ECM fault
How it failed
You'll notice: A yellow lamp is lit and the engine will not start until the VIN is available from the other modules.
Erratic or implausibleRead from FMI 2: erratic or incorrect data
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 128 engine ECU - module, data link and power
- MID 128 SID 39 FMI 3Starter relay output shorted high
- MID 128 SID 39 FMI 5Starter relay circuit open
- MID 128 PID 158 FMI 1ECM battery voltage too low
- MID 128 PID 158 FMI 3ECM battery voltage too high
- MID 128 PSID 201 FMI 9Message from instrument cluster missing
- MID 128 PSID 229 FMI 2SAE J1939 data link 2 circuit shorted or open
- MID 128 PSID 229 FMI 9SAE J1939 data link 2 - lost communication with aftertreatment module
- MID 128 SID 231 FMI 2SAE J1939 data link (CAN 1) circuit fault
Related on Equipments Finder
Source
This source lists MID 128 PSID 161 FMI 2 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
