EF Logo

Volvo/Mack · MID 128 engine ECU - sensors and levels

Volvo/Mack Fault Code MID 128 PID 98 FMI 1

Engine oil level critically low

What does Volvo/Mack code MID 128 PID 98 FMI 1 mean?

The oil level sensor in the sump reports oil critically below the allowed range. The ECM takes this as a real low-oil condition, not an electrical fault, and the severity decides whether the red or yellow lamp shows. Urgency: stop now - shut down and fix before working on. Check first: park level, wait a few minutes and read the dipstick; the dipstick is the reference, not the cluster.

FaultStopMID 128PID 98FMI 1Volvo/Mack · MID 128 engine ECU - sensors and levels
MID 128
Which control unit reports it
PID 98
Parameter at fault
FMI 1
Data below normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Park level, wait a few minutes and read the dipstick; the dipstick is the reference, not the cluster

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Oil actually low from consumption or a leak since the last service
  • Oil level not topped up after an oil change or turbo service
  • Overfill followed by loss on a long climb, leaving the sump reading low

How it failed

You'll notice: A red stop lamp or a yellow check lamp lights depending on how low the oil is, and the cluster may show a low oil level message.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Oil pressure, oil level and oil temperature

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PID 98 FMI 1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.