Komatsu · Monitor user codes
Komatsu Fault Code E0E
Network (data link) failure
What does Komatsu code E0E mean?
User code E0E points to a failure on the machine data link. The controllers can no longer exchange data, so the monitor may lose engine or pump information and some functions may drop out. Urgency: check soon - the machine may derate or limit a function. Check first: read DA2RMC or CA1633 in service mode to see which controller is missing.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read DA2RMC or CA1633 in service mode to see which controller is missing
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- CAN or KOMNET data link wire open or shorted
- Pump or engine controller without power or ground
- Loose controller connector
- Controller left on the wrong software after replacement
How it failed
You'll notice: Network failure on the monitor with E0E.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Operator user codes (E02, E03, E05, E10 and similar)
- E0ENetwork (data link) failureLost messageCheck soon
- E02PC-EPC systemOtherCheck soon
- E03Swing parking brake systemOtherCheck soon
- E05Governor motor systemOtherCheck soon
- E10Engine controller power or drive failureOtherCheck soon
- E11Engine control system failure, output limitedOtherCheck soon
- E14Feedback system failure (throttle circuit)OtherCheck soon
- E15Engine sensor failureOtherCheck soon
Other Komatsu codes: Monitor user codes
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists E0E and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
