EF Logo

Komatsu · Pump controller

Komatsu Fault Code DHPAMA

Front pump pressure sensor abnormal

What does Komatsu code DHPAMA mean?

The front pump pressure sensor signal is outside range or not following the real pump pressure. The pump controller may set pump output wrongly, which can show up as slow or weak working equipment. Urgency: check soon - the machine may derate or limit a function. Check first: check the sensor supply and the DA25KP code first.

FaultCheckDHPAMAKomatsu · Pump controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the sensor supply and the DA25KP code first

Then 4 more checks
Code shows hereFAULTDHPAMA

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 5 done

Causes

  • Front pump pressure sensor connector loose, oily or corroded
  • Sensor wire open or shorted
  • Failed front pump pressure sensor
  • Blocked sensor port
1 more cause
  • 5 V sensor supply low

How it failed

You'll notice: Working equipment slow or weak with DHPAMA on the monitor.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Pump, PPC, load and oil temperature sensors

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists DHPAMA and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.