EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA559

Common rail pressure too low (stage 1)

What does Komatsu code CA559 mean?

The rail pressure stays below the commanded value. The injectors may not deliver the full amount of fuel and the engine loses power or starts hard. Urgency: check soon - the machine may derate or limit a function. Check first: change the fuel filters and bleed the low pressure circuit before further tests.

FaultCheckCA559Komatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Change the fuel filters and bleed the low pressure circuit before further tests

Then 4 more checks
Code shows hereFAULTCA559

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 5 done

Causes

  • Restricted fuel filter or air in the low pressure line
  • Worn supply pump
  • Leaking injector or rail connection
  • IMV valve stuck open
1 more cause
  • Water in the fuel

How it failed

You'll notice: Loss of power or hard starting with CA559 on the monitor.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Common rail fuel pressure

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA559 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.