John Deere · Engine control unit (ECU) - Exhaust
John Deere Fault Code ECU 003701.14
Parked exhaust filter cleaning requested
What does John Deere code ECU 003701.14 mean?
The ECU is asking for a parked exhaust filter cleaning because soot loading is high. The operator may see a request lamp, and ignoring it can lead to power derate and a forced service. Urgency: information - a reminder or status message. Check first: park the machine outdoors away from anything that burns and start the parked regeneration.
- ECU
- Which controller reports it
- 003701
- What is at fault
- .14
- Special instructions
Can I keep running with it?
Information
A reminder or status message. Nothing is failing yet.
What should I check first?
Park the machine outdoors away from anything that burns and start the parked regeneration
Then 4 more checksWhere this code shows
Turn the key on and open the monitor's diagnostic/fault screen.
Checks
0 of 5 done
Causes
- Soot loading high from short work cycles that prevent automatic regeneration
- Regeneration interrupted by shutting the engine down
- Parked regeneration not run when the lamp came on
- An engine problem raising soot output
How it failed
You'll notice: The ECU is asking for a parked exhaust filter cleaning because soot loading is high.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Air filter, exhaust filter, fuel level and monitor sensors
- ECU 000107.00Air filter differential pressure highReal conditionCheck soon
- ECU 003701.14Parked exhaust filter cleaning requestedLost messageInformation
- DSZ 13303.02Monitor internal temperature sensor abnormalOtherCheck soon
- ICZ 13303.02Monitor internal temperature sensor abnormalOtherCheck soon
- DSZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- ICZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- DSZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- ICZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- MCZ 20010.02Exhaust filter abnormalOtherCheck soon
Show the other 4 codesHide the other codes
Related on Equipments Finder
Source
Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)
This source lists ECU 003701.14 and its meaning. The guidance on this page is general, not taken from it.
The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
