John Deere · Main controller (MCZ) - alarms
John Deere Fault Code MCZ 20010.02
Exhaust filter abnormal
What does John Deere code MCZ 20010.02 mean?
The exhaust filter alarm is raised, usually soot loading that regeneration has not cleared. Left alone the engine will derate. Urgency: check soon - the machine may derate or limit a function. Check first: read the soot load and last regeneration on the monitor and run a parked regeneration if the machine allows one.
- MCZ
- Which controller reports it
- 20010
- What is at fault
- .02
- How it failed
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the soot load and last regeneration on the monitor and run a parked regeneration if the machine allows one
Then 4 more checksWhere this code shows
Turn the key on and open the monitor's diagnostic/fault screen.
Checks
0 of 5 done
Causes
- Soot loading too high because regeneration keeps being interrupted by short work cycles or by shutting down mid-clean
- Engine running with an air or fuel fault that loads the filter faster than it can burn off
- Exhaust filter differential pressure sensor or its hoses blocked or leaking
- Filter itself blocked with ash and past its cleaning interval
How it failed
You'll notice: The exhaust filter alarm means soot has built up in the particulate filter and regeneration has not cleared it.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Air filter, exhaust filter, fuel level and monitor sensors
- DSZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- ICZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- DSZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- ICZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- MCZ 20010.02Exhaust filter abnormalOtherCheck soon
- DSZ 20106.02Air cleaner restriction alarmReal conditionCheck soon
- ECU 020106.02Air cleaner restriction alarmReal conditionCheck soon
- ICZ 20137.02Exhaust filter alarmOtherCheck soon
- ICZ 20141.02Exhaust temperature alarmOtherCheck soon
Show the other 4 codesHide the other codes
Other John Deere codes: Main controller (MCZ) - alarms
Related on Equipments Finder
Source
Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)
This source lists MCZ 20010.02 and its meaning. The guidance on this page is general, not taken from it.
The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
