John Deere · Engine control unit (ECU) - Engine air
John Deere Fault Code ECU 000107.00
Air filter differential pressure high
What does John Deere code ECU 000107.00 mean?
The engine ECU sees air filter restriction at the most severe level. Urgency: check soon - the machine may derate or limit a function. Check first: take the air cleaner element out and look at it against a light; a dark clogged element confirms the cause.
- ECU
- Which controller reports it
- .00
- Data above normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Take the air cleaner element out and look at it against a light; a dark clogged element confirms the cause
Then 4 more checksWhere this code shows
Turn the key on and open the monitor's diagnostic/fault screen.
Checks
0 of 5 done
Causes
- Air cleaner element clogged with dust, especially after work in dry or dusty ground
- Dust cap or pre-cleaner packed so air cannot get in
- Intake pipe collapsed or a hose soft on the suction side
- Air filter restriction sensor or its wiring faulty
How it failed
You'll notice: The engine ECU sees the air filter restriction at its worst level.
Real conditionRead from how the source describes the code
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Air filter, exhaust filter, fuel level and monitor sensors
2 other codes on this part are also real condition (DSZ 20106.02, ECU 020106.02). When they show together, start at the wiring and connector they share.
- ECU 000107.00Air filter differential pressure highReal conditionCheck soon
- ECU 003701.14Parked exhaust filter cleaning requestedLost messageInformation
- DSZ 13303.02Monitor internal temperature sensor abnormalOtherCheck soon
- ICZ 13303.02Monitor internal temperature sensor abnormalOtherCheck soon
- DSZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- ICZ 13311.03Fuel level sensor (B18) open circuitOpen circuitInformation
- DSZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- ICZ 13311.04Fuel level sensor (B18) shorted to groundShorted lowInformation
- MCZ 20010.02Exhaust filter abnormalOtherCheck soon
Show the other 4 codesHide the other codes
Related on Equipments Finder
Source
Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)
This source lists ECU 000107.00 and its meaning. The guidance on this page is general, not taken from it.
The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
