EF Logo

John Deere · Engine control unit (ECU) - PowerTech engine

John Deere Fault Code ECU 000110.00

Coolant temperature high

What does John Deere code ECU 000110.00 mean?

The ECU sees engine coolant temperature above the limit. The operator may see an overheat warning and a derate, and running on can crack the head or blow the gasket. Urgency: stop now - shut down and fix before working on. Check first: let the engine idle to cool and check the coolant level when cold.

FaultStopECU000110.00John Deere · Engine control unit (ECU) - PowerTech engine
ECU
Which controller reports it
.00
Data above normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Let the engine idle to cool and check the coolant level when cold

Then 4 more checks
Code shows hereFAULTECU000110.00

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Coolant level low from a leak
  • Radiator or cooler blocked with debris
  • Thermostat stuck closed or the water pump failing
  • Fan or fan drive not working

How it failed

You'll notice: The ECU sees engine coolant temperature above its limit.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine coolant, intake air and fuel temperature

2 other codes on this part are also shorted high (ECU 000105.00, ECU 000174.00). When they show together, start at the wiring and connector they share.

Show the other 11 codes
All 20 Engine coolant, intake air and fuel temperature codes on one page

Source

Inside the Yard - John Deere fault codes list (ECU engine codes)

This source lists ECU 000110.00 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere PowerTech engines; code list comes from tractor-based sources, confirm for your machine.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.