EF Logo

John Deere · Engine control unit (ECU) - Cooling

John Deere Fault Code ECU 000111.01

Coolant level low

What does John Deere code ECU 000111.01 mean?

The coolant level sensor shows the coolant level is low. The operator may see a low coolant warning, and running on risks overheating and engine damage. Urgency: stop now - shut down and fix before working on. Check first: with the engine cold, check the coolant level in the surge tank and top it up with the correct coolant.

FaultStopECU000111.01John Deere · Engine control unit (ECU) - Cooling
ECU
Which controller reports it
.01
Data below normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

With the engine cold, check the coolant level in the surge tank and top it up with the correct coolant

Then 4 more checks
Code shows hereFAULTECU000111.01

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Coolant level really low from a leak or an overdue top-up
  • Radiator or surge tank cap not sealing and letting coolant out
  • Coolant level sensor faulty or coated with deposits
  • Level sensor wiring damaged

How it failed

You'll notice: The coolant level sensor says the coolant is low.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine coolant, intake air and fuel temperature

1 other code on this part is also real condition (ECU 000111.07). When they show together, start at the wiring and connector they share.

Show the other 11 codes
All 20 Engine coolant, intake air and fuel temperature codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists ECU 000111.01 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.