JCB · Engine ECU (Dieselmax / Ecomax) - electrical
JCB Fault Code P0563
System voltage high
What does JCB code P0563 mean?
System voltage went above about 15.5 V, which means the charging system is overcharging. It can damage the battery and electronics and may make the ECU log other voltage-related faults. Urgency: check soon - the machine may derate or limit a function. Check first: measure the battery voltage with the engine running at a steady speed and see if it is above the limit.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure the battery voltage with the engine running at a steady speed and see if it is above the limit
Then 5 more checksWhere this code shows
Switch the key on and note any warning lamp or fault icon on the cluster.
Checks
0 of 6 done
Causes
- Alternator regulator failed and allowing too high output
- Poor sensing or earth connection at the alternator that makes the regulator overcompensate
- Loose or corroded battery connection giving a misreading at the ECU
- Wrong or failing battery that cannot take charge
1 more causeFewer causes
- Wiring fault between the alternator and the ECU supply
How it failed
You'll notice: The alternator is overcharging, so the battery may boil, lamps can burn out and the electronics can be damaged.
Shorted highRead from how the source describes the code
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, charging, warning lamps and service interval
2 other codes on this part are also shorted high (C1025, C1027). When they show together, start at the wiring and connector they share.
- B130ASupplementary service interval due / elapsedOtherInformation
- P0560System voltage faultOtherCheck soon
- P0562System voltage lowShorted lowCheck soon
- P0563System voltage highShorted highCheck soon
- P0650Malfunction indicator lamp control circuit faultOtherInformation
- P0655Engine test indicator lamp malfunctionOtherInformation
- B1002Alternator not chargingOtherCheck soon
- C1025Battery voltage high faultShorted highCheck soon
- C1026Battery voltage low faultShorted lowCheck soon
Show the other 4 codesHide the other codes
Other JCB codes: Engine ECU (Dieselmax / Ecomax) - electrical
Related on Equipments Finder
Source
Partao JCB fault code P0563 page
This source lists P0563 and its meaning. The guidance on this page is general, not taken from it.
The source covers: 2CX-5CX, 525-60, 531-70, 535-140, 540-170, JS130-JS260, skid steers.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
