JCB · Machine controller (MECU / DECU)
JCB Fault Code C1025
Battery voltage high fault
What does JCB code C1025 mean?
Battery voltage as seen by the controller is above its limit. The operator may see a charging warning, and electronics can be damaged by sustained overvoltage. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine running and compare it with the controller reading.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure battery voltage with the engine running and compare it with the controller reading
Then 5 more checksWhere this code shows
Switch the key on and note any warning lamp or fault icon on the cluster.
Checks
0 of 6 done
Causes
- Alternator regulator failed high
- Poor earth or sensing wire letting the alternator overcharge
- Loose battery terminal confusing the voltage reading
- Wrong or failed battery
1 more causeFewer causes
- Controller voltage sensing wire damaged
How it failed
You'll notice: The controller sees battery voltage above its limit.
Shorted highRead from how the source describes the code
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, charging, warning lamps and service interval
2 other codes on this part are also shorted high (P0563, C1027). When they show together, start at the wiring and connector they share.
- P0563System voltage highShorted highCheck soon
- P0650Malfunction indicator lamp control circuit faultOtherInformation
- P0655Engine test indicator lamp malfunctionOtherInformation
- B1002Alternator not chargingOtherCheck soon
- C1025Battery voltage high faultShorted highCheck soon
- C1026Battery voltage low faultShorted lowCheck soon
- C1027Alternator voltage high faultShorted highCheck soon
- C1028Alternator voltage low faultShorted lowCheck soon
- B1309Service interval due / elapsedOtherInformation
Show the other 4 codesHide the other codes
Other JCB codes: Machine controller (MECU / DECU)
Related on Equipments Finder
Source
Partao JCB fault code list, page 2 (code table)
This source lists C1025 and its meaning. The guidance on this page is general, not taken from it.
The source covers: JCB machines with MECU/DECU.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
