EF Logo

JCB · Instrument cluster / MECU

JCB Fault Code B1002

Alternator not charging

What does JCB code B1002 mean?

The cluster or controller sees no charge from the alternator while the engine is running. The operator sees the charging warning lamp, and the battery will drain until the fault is fixed. Urgency: check soon - the machine may derate or limit a function. Check first: check the drive belt is present, tight and in good condition.

FaultCheckB1002JCB · Instrument cluster / MECU

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the drive belt is present, tight and in good condition

Then 5 more checks
Code shows hereFAULTB1002

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • Alternator failed and not producing charge
  • Drive belt broken, slipping or off the pulley
  • Loose or corroded alternator output cable
  • Alternator excitation wire open
1 more cause
  • Cluster or controller sensing the charge signal wrongly

How it failed

You'll notice: The charging warning lamp is on and the battery will go flat if the machine keeps working with no charge.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: System voltage, charging, warning lamps and service interval

Source

Partao JCB fault code list, page 1 (code table)

This source lists B1002 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JCB machines with cluster.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.