J1939 · Aftertreatment - SCR/DEF
SPN 5798 Fault Code
DEF pump module temperature
What does SPN 5798 mean?
Temperature inside the DEF pump module, used to judge thawing and heater control. How urgent it is depends on the FMI after SPN 5798 - pick it below. Check first: compare the module temperature with ambient after a cold soak.
- SPN 5798
- DEF pump module temperature
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5798 - pick it below.
What should I check first?
Compare the module temperature with ambient after a cold soak
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5798?
You'll notice: The controller cannot tell whether the pump module is thawed, so it may hold back dosing.
Find the number shown after SPN 5798 on your display.
- 2SPN 5798 FMI 2: DEF pump module temperature data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, PACCAR MX-13
- 10SPN 5798 FMI 10: DEF pump module temperature is changing at an abnormal rateErratic or implausibleCummins ISX15, PACCAR MX-13
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5798 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Temperature sensor inside the module failed
- Module connector corroded
- Heater relay stuck on
- Module electronics fault
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5798 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15, PACCAR MX-13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
