J1939 · Aftertreatment - SCR/DEF
SPN 5400 Fault Code
Aftertreatment SCR thermal management
What does SPN 5400 mean?
The ECM strategy that raises exhaust temperature so the SCR can work. A status here means thermal management is active or has a condition. How urgent it is depends on the FMI after SPN 5400 - pick it below. Check first: check the SCR inlet and outlet temperatures in the service tool at a steady working load.
- SPN 5400
- Aftertreatment SCR thermal management
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5400 - pick it below.
What should I check first?
Check the SCR inlet and outlet temperatures in the service tool at a steady working load
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5400?
You'll notice: SCR thermal management is active, so the ECM is raising exhaust temperature to bring the catalyst up to working temperature.
Find the number shown after SPN 5400 on your display.
- 31SPN 5400 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5400 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Low exhaust temperature from long idling or light-load work, so the catalyst stays cold
- SCR inlet or outlet temperature sensor reading low
- Thermal management blocked or limited by another aftertreatment fault
- Exhaust leak ahead of the SCR cooling the gas
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5400 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
