J1939 · Aftertreatment - DPF
SPN 520349 Fault Code
DPF filtration efficiency
What does SPN 520349 mean?
The controller's judgement of how well the DPF is filtering soot, which it gets from the soot sensor. How urgent it is depends on the FMI after SPN 520349 - pick it below. Check first: inspect the DPF and the tailpipe for soot staining or signs of filter damage.
- SPN 520349
- DPF filtration efficiency
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 520349 - pick it below.
What should I check first?
Inspect the DPF and the tailpipe for soot staining or signs of filter damage
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 520349?
You'll notice: The DPF may be cracked, melted or removed, so emissions are too high and a derate can be set.
Find the number shown after SPN 520349 on your display.
- 14SPN 520349 FMI 14: Special-instruction fault for the DPF filtration efficiency; the maker lists a dedicated procedure for itOtherDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 520349 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Cracked or melted DPF substrate
- Filter removed or replaced
- Soot sensor reading wrongly
- Exhaust leak before the sensor
Other Aftertreatment - DPF codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 520349 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
