J1939 · Aftertreatment - DPF
SPN 520348 Fault Code
Soot sensor sampling tube
What does SPN 520348 mean?
Condition of the tube that samples exhaust gas for the soot sensor. How urgent it is depends on the FMI after SPN 520348 - pick it below. Check first: remove the soot sensor and inspect the sampling tube for blockage.
- SPN 520348
- Soot sensor sampling tube
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 520348 - pick it below.
What should I check first?
Remove the soot sensor and inspect the sampling tube for blockage
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 520348?
You'll notice: A blocked or defective tube makes the sensor read wrong, so the DPF monitor may fail.
Find the number shown after SPN 520348 on your display.
- 14SPN 520348 FMI 14: Special-instruction fault for the Soot sensor sampling tube; the maker lists a dedicated procedure for itOtherDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 520348 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Tube blocked by soot or ash
- Tube damaged
- Sensor fitted without the tube
- DPF passing too much soot
Other Aftertreatment - DPF codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 520348 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
