EF Logo

J1939 · Aftertreatment - DPF

SPN 3246 Fault Code

Aftertreatment 1 diesel particulate filter outlet gas temperature

What does SPN 3246 mean?

Exhaust temperature leaving the DPF, read by a sensor at the filter outlet. The ECM uses it to manage regeneration and to protect downstream parts. How urgent it is depends on the FMI after SPN 3246 - pick it below. Check first: compare the outlet temperature with the DPF inlet reading; outside a regeneration the two should be close.

FaultActiveSPN 3246FMI --J1939 engine ECU
SPN 3246
Aftertreatment 1 diesel particulate filter outlet gas temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3246 - pick it below.

What should I check first?

Compare the outlet temperature with the DPF inlet reading; outside a regeneration the two should be close

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3246?

You'll notice: The ECM cannot see the gas temperature leaving the particulate filter, so it cannot tell whether a regeneration is burning soot safely.

Find the number shown after SPN 3246 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3246 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Reads cold: an open circuit or a short to supply in the DPF outlet temperature sensor wiring, which the ECM reads as an extremely low temperature
  • Reads hot: signal wire shorted to ground or the DPF outlet temperature sensor element shorted, which the ECM reads as an extremely high temperature
  • Real condition: regeneration not reaching full temperature, so the outlet stays cold and the soot is not burning
  • Real condition: dPF canister damaged or melted, so outlet gas temperature runs off the expected curve
1 more cause
  • Sensor: outlet temperature lagging the inlet during regeneration because the filter holds heat

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3246 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.