EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4363 Fault Code

Aftertreatment 1 SCR outlet gas temperature

What does SPN 4363 mean?

Exhaust temperature leaving the SCR catalyst, read by a sensor after it. The ECM uses it to check catalyst operation and thermal management. How urgent it is depends on the FMI after SPN 4363 - pick it below. Check first: under load compare the SCR outlet temperature with the SCR intake temperature; the outlet should follow with a small offset.

FaultActiveSPN 4363FMI --J1939 engine ECU
SPN 4363
Aftertreatment 1 SCR outlet gas temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4363 - pick it below.

What should I check first?

Under load compare the SCR outlet temperature with the SCR intake temperature; the outlet should follow with a small offset

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4363?

You'll notice: The ECM cannot see the gas temperature leaving the SCR catalyst, so it cannot confirm the catalyst is working or limit a hot-catalyst condition.

Find the number shown after SPN 4363 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4363 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Reads cold: an open circuit or a short to supply in the SCR outlet temperature sensor wiring, which the ECM reads as an extremely low temperature
  • Reads hot: signal wire shorted to ground or the SCR outlet temperature sensor element shorted, which the ECM reads as an extremely high temperature
  • Real condition: catalyst damage or a blocked mixer changing the real outlet temperature
  • Real condition: tailpipe or silencer joint leak after the SCR, cooling the gas at the sensor
1 more cause
  • Sensor: road spray and rain getting into the plug and making the reading jump

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4363 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.