EF Logo

J1939 · Aftertreatment - DPF

SPN 3556 Fault Code

Aftertreatment 1 hydrocarbon doser

What does SPN 3556 mean?

The fuel injector (doser) that injects diesel into the exhaust to heat the DOC for regeneration, and its drive circuit. The ECM commands it during active regeneration. How urgent it is depends on the FMI after SPN 3556 - pick it below. Check first: run the doser test with the service tool and listen for the doser click.

FaultActiveSPN 3556FMI --J1939 engine ECU
SPN 3556
Aftertreatment 1 hydrocarbon doser
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3556 - pick it below.

What should I check first?

Run the doser test with the service tool and listen for the doser click

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3556?

You'll notice: The hydrocarbon doser is not working, so the DPF cannot be regenerated by dosing.

Find the number shown after SPN 3556 on your display.

  • 2SPN 3556 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15
  • 3SPN 3556 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, Volvo D13
  • 4SPN 3556 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowMack MP8, Mack MP7, Volvo D13
  • 5SPN 3556 FMI 5: Current is below normal, or the circuit is openOpen circuitCummins ISX15, Mack MP8, Mack MP7, Volvo D13
  • 7SPN 3556 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerCummins ISX15
  • 13SPN 3556 FMI 13: The value is out of calibrationPart or controllerMack MP8, Mack MP7, Volvo D13
  • 14SPN 3556 FMI 14: A special-instruction condition defined by the engine maker appliesOtherMack MP8, Mack MP7, Volvo D13
  • 18SPN 3556 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

How urgent SPN 3556 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Doser circuit open or shorted: broken wire, corroded plug or chafed lead at the doser
  • Doser nozzle blocked by carbon, so it cannot spray
  • Doser fuel supply restricted by the filter, the shutoff valve or a line
  • ECM doser driver fault, which is rare and only after the wiring is cleared

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3556 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.