J1939 · Aftertreatment - DPF
SPN 5298 Fault Code
Aftertreatment 1 diesel oxidation catalyst conversion efficiency
What does SPN 5298 mean?
How well the DOC converts hydrocarbons, judged from the temperature rise during dosing. It is used to detect an aged or damaged catalyst. How urgent it is depends on the FMI after SPN 5298 - pick it below. Check first: run a regeneration and compare the DOC inlet and outlet temperatures in the service tool.
- SPN 5298
- Aftertreatment 1 diesel oxidation catalyst conversion efficiency
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5298 - pick it below.
What should I check first?
Run a regeneration and compare the DOC inlet and outlet temperatures in the service tool
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5298?
You'll notice: The diesel oxidation catalyst is not converting as expected, so the temperature rise needed for regeneration is poor.
Find the number shown after SPN 5298 on your display.
- 2SPN 5298 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleMack MP8, Mack MP7, Volvo D13
- 7SPN 5298 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerMack MP8, Mack MP7, Volvo D13
- 17SPN 5298 FMI 17: Value is below the normal range, least severe levelReal conditionCummins ISX15
- 18SPN 5298 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5298 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- DOC contaminated by oil, fuel or sulphur and no longer lighting off
- Hydrocarbon doser or in-cylinder dosing not delivering enough fuel
- DOC inlet or outlet temperature sensor reading wrongly, so the temperature rise looks too small
- Exhaust leak ahead of the DOC cooling the gas
Other Aftertreatment - DPF codes
- SPN 5018Diesel oxidation catalyst plugged
- SPN 3556Aftertreatment doser (hydrocarbon injector)
- SPN 81DPF intake pressure
- SPN 3242DPF intake temperature sensor
- SPN 3245DPF outlet temperature
- SPN 3246DPF outlet temperature sensor
- SPN 3249DPF intake temperature
- SPN 3250Diesel oxidation catalyst outlet temperature
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5298 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
