J1939 · Aftertreatment - DPF
SPN 3251 FMI 3
DPF differential pressure sensor voltage high
What does SPN 3251 FMI 3 mean?
The DPF differential pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: with the key on, watch the DPF differential pressure sensor live; if it sits at maximum at once the fault is solid rather than intermittent.
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
With the key on, watch the DPF differential pressure sensor live; if it sits at maximum at once the fault is solid rather than intermittent
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal pin backed out or broken in the DPF differential pressure sensor connector, leaving the ECM input unconnected
- Ground lost at the DPF differential pressure sensor, or the signal shorted to a supply wire in the same harness run
- Sensor plug damaged by exhaust heat, with a loose pin
- Pressure hoses swapped, kinked or melted at the filter taps, giving a false full-scale reading
1 more causeFewer causes
- Sensor left disconnected or damaged after DPF cleaning or removal
How it failed
You'll notice: The ECM cannot read soot load, so regeneration timing is wrong and the filter can load up, with the DPF lamp on and power cut back when pressure readings are false.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3251 codes
- SPN 3251Aftertreatment 1 diesel particulate filter differential pressure - every FMI
- SPN 3251 FMI 0DPF differential pressure high, most severe
- SPN 3251 FMI 2DPF differential pressure erratic
- SPN 3251 FMI 4DPF differential pressure sensor voltage low
- SPN 3251 FMI 10DPF differential pressure abnormal rate of change
- SPN 3251 FMI 16DPF differential pressure high, moderately severe
- SPN 3251 FMI 21DOC inlet/outlet pressure implausible
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3251 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
