J1939 · Aftertreatment - DPF
SPN 3251 FMI 4
DPF differential pressure sensor voltage low
What does SPN 3251 FMI 4 mean?
The DPF differential pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the DPF differential pressure sensor live with the key on; if it reads near zero from power-up the fault is steady.
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the DPF differential pressure sensor live with the key on; if it reads near zero from power-up the fault is steady
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal circuit touching ground in the harness, which drags the DPF differential pressure sensor reading to zero
- Reference wire to the DPF differential pressure sensor open or shorted, so the sensor has nothing to power it
- Both pressure hoses pulled off or split, so the sensor sees equal pressure and reads zero drop
- Sensor supply lost at the plug from heat damage near the canister
1 more causeFewer causes
- Signal wire shorted to the canister bracket
How it failed
You'll notice: The ECM cannot read soot load, so regeneration timing is wrong and the filter can load up, with the DPF lamp on and power cut back when pressure readings are false.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3251 codes
- SPN 3251Aftertreatment 1 diesel particulate filter differential pressure - every FMI
- SPN 3251 FMI 0DPF differential pressure high, most severe
- SPN 3251 FMI 2DPF differential pressure erratic
- SPN 3251 FMI 3DPF differential pressure sensor voltage high
- SPN 3251 FMI 10DPF differential pressure abnormal rate of change
- SPN 3251 FMI 16DPF differential pressure high, moderately severe
- SPN 3251 FMI 21DOC inlet/outlet pressure implausible
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3251 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
