EF Logo

J1939 · Turbo

SPN 102 Fault Code

Engine intake manifold 1 pressure

What does SPN 102 mean?

Boost pressure in the intake manifold, read by the manifold pressure sensor. The ECM uses it for fuel limits, turbo control and EGR calculations. How urgent it is depends on the FMI after SPN 102 - pick it below. Check first: compare the key-on, engine-off reading with barometric pressure: the two should be close, so full scale here confirms an electrical fault.

FaultActiveSPN 102FMI --J1939 engine ECU
SPN 102
Engine intake manifold 1 pressure
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 102 - pick it below.

What should I check first?

Compare the key-on, engine-off reading with barometric pressure: the two should be close, so full scale here confirms an electrical fault

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 102?

You'll notice: Boost reads wrong, so the ECM trims fuel and the engine feels down on power with extra smoke, and the check-engine lamp may come on.

Find the number shown after SPN 102 on your display. 3 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

How urgent SPN 102 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Signal high or open: broken or backed-out pin, an open sensor return, or the signal shorted to the 5 V reference at the intake manifold pressure sensor
  • Signal low or shorted: signal wire grounded, or the 5 V reference lost, so the intake manifold pressure sensor reads at the bottom of its range
  • Real condition: boost leak at a charge air cooler hose clamp or the cooler itself, so real boost is below target
  • Real condition: turbo not building boost from a stuck vane, wastegate or worn turbo
1 more cause
  • Sensor: oil or soot in the sensor port, making the reading lag and jump instead of following boost smoothly

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 102 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.