J1939 · Turbo
SPN 642 Fault Code
Variable geometry turbocharger actuator 2
What does SPN 642 mean?
Second variable-geometry turbocharger actuator, on engines with two turbo stages, with a position and command output to the ECM. How urgent it is depends on the FMI after SPN 642 - pick it below. Check first: measure the second actuator coil resistance at its connector and compare it with the first stage.
- SPN 642
- Variable geometry turbocharger actuator 2
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 642 - pick it below.
What should I check first?
Measure the second actuator coil resistance at its connector and compare it with the first stage
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 642?
You'll notice: Boost control on the second stage is off, so the engine may lose power, over-boost or smoke.
Find the number shown after SPN 642 on your display.
- 0SPN 642 FMI 0: Variable geometry turbocharger actuator 2 is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 16SPN 642 FMI 16: Variable geometry turbocharger actuator 2 is above the normal range, moderately severe levelReal conditionMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 642 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Second-stage vane linkage stuck
- Actuator coil open
- Turbo bearing failing
- Harness damaged
Other Turbo codes
- SPN 2795VTG turbocharger actuator position
- SPN 3675Turbocharger compressor bypass valve
- SPN 102Intake manifold (boost) pressure
- SPN 103Turbocharger 1 speed
- SPN 641Variable geometry turbo (VGT) actuator
- SPN 1127Turbocharger boost (intake manifold) pressure
- SPN 1172Turbo compressor inlet temperature sensor
- SPN 1176Turbocharger compressor inlet pressure
Source
Mack MP8 2010-2013 fault code list (Diesel Laptops)
This list names SPN 642 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Mack MP7, Mack MP8, Volvo D13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
