J1939 · Turbo
SPN 102 FMI 4
Intake manifold pressure sensor voltage low
What does SPN 102 FMI 4 mean?
The intake manifold pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the intake manifold pressure sensor live with the key on; if it reads near zero from power-up the fault is steady.
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the intake manifold pressure sensor live with the key on; if it reads near zero from power-up the fault is steady
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal circuit touching ground in the harness, which drags the intake manifold pressure sensor reading to zero
- Reference wire to the intake manifold pressure sensor open or shorted, so the sensor has nothing to power it
- Pressure port or short hose to the manifold split or pulled off, so the sensor sees outside air only
- Signal wire chafed against the manifold bracket or the turbo pipe
1 more causeFewer causes
- Connector filled with charge-air oil mist, which can leak signal to ground
How it failed
You'll notice: Boost reads wrong, so the ECM trims fuel and the engine feels down on power with extra smoke, and the check-engine lamp may come on.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 102 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 102 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
