J1939 · Turbo
SPN 1188 Fault Code
Engine turbocharger wastegate drive 1
What does SPN 1188 mean?
The command that moves the turbo wastegate to bleed off exhaust energy and limit boost. The ECM drives it as part of boost control. How urgent it is depends on the FMI after SPN 1188 - pick it below. Check first: command the wastegate actuator in the service tool and see that it moves smoothly to the commanded position.
- SPN 1188
- Engine turbocharger wastegate drive 1
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 1188 - pick it below.
What should I check first?
Command the wastegate actuator in the service tool and see that it moves smoothly to the commanded position
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 1188?
You'll notice: The wastegate actuator is not following its commanded position, so boost cannot be controlled.
Find the number shown after SPN 1188 on your display.
- 7SPN 1188 FMI 7: Wastegate actuator is in fail-safe mode with its motor off because the position is wrongPart or controllerDetroit engines on GHG17
- 10SPN 1188 FMI 10: Wastegate actuator position deviates from the commanded position (second check)Erratic or implausibleDetroit engines on GHG17
- 11SPN 1188 FMI 11: Wastegate actuator learned travel span is too small (range 2)OtherDetroit engines on GHG17
- 14SPN 1188 FMI 14: Wastegate actuator power is limitedOtherDetroit engines on GHG17
- 31SPN 1188 FMI 31: Wastegate actuator position deviates from the commanded positionReal conditionDetroit engines on GHG17
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 1188 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Actuator circuit fault: wiring open, shorted or chafed at the actuator plug
- Wastegate stuck from carbon or a seized linkage
- Actuator motor or position feedback worn or failed
- Learned travel range wrong after a turbo or actuator replacement
Other Turbo codes
- SPN 1127Turbocharger boost (intake manifold) pressure
- SPN 641Variable geometry turbo (VGT) actuator
- SPN 642Variable geometry turbocharger actuator 2
- SPN 1172Turbo compressor inlet temperature sensor
- SPN 1176Turbocharger compressor inlet pressure
- SPN 1209Exhaust gas pressure
- SPN 2629Turbocharger compressor outlet temperature
- SPN 2789Turbocharger turbine inlet temperature
Source
Detroit Diesel bulletin SPN 1188 (MCM) GHG17, DDC-SVC-MAN-0200 update (NHTSA)
This list names SPN 1188 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit GHG17 engines with the motor control module (MCM); same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
