EF Logo

J1939 · Air intake

SPN 105 Fault Code

Engine intake manifold 1 temperature

What does SPN 105 mean?

Temperature of the charge air in the intake manifold, read by a sensor in the manifold. The ECM uses it for fuelling, boost and EGR corrections. How urgent it is depends on the FMI after SPN 105 - pick it below. Check first: compare the manifold temperature with ambient and coolant after a cold overnight soak; all three should match closely.

FaultActiveSPN 105FMI --J1939 engine ECU
SPN 105
Engine intake manifold 1 temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 105 - pick it below.

What should I check first?

Compare the manifold temperature with ambient and coolant after a cold overnight soak; all three should match closely

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 105?

You'll notice: Charge air temperature is misread, so the ECM can trim fuel and timing wrongly and the cold-start strategy may stay on.

Find the number shown after SPN 105 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

How urgent SPN 105 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Reads cold: an open circuit or a short to supply in the intake manifold temperature sensor wiring, which the ECM reads as an extremely low temperature
  • Reads hot: signal wire shorted to ground or the intake manifold temperature sensor element shorted, which the ECM reads as an extremely high temperature
  • Real condition: charge air cooler dirty or blocked, giving a real manifold temperature higher than expected
  • Real condition: sensor aged and reading slowly from heat soak
1 more cause
  • Sensor: poor contact between the sensor tip and the air stream, so the reading lags and wanders

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 105 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.