EF Logo

J1939 · Air intake

SPN 105 FMI 3

Intake manifold temperature sensor voltage high

What does SPN 105 FMI 3 mean?

The intake manifold temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the intake manifold temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.

FaultCheckSPN 105FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the intake manifold temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Broken wire or pulled-back pin at the intake manifold temperature sensor; an open thermistor circuit reads as very cold
  • Return wire open or the signal touching a supply circuit, either of which reads as full voltage
  • Sensor pulled partly out of its boss in the intake elbow, so the tip sits in the wrong place and the clip is cracked
  • Connector forgotten after the charge pipe or air filter housing was lifted off
1 more cause
  • Lead broken inside its sleeve at the first clip behind the plug on the manifold

How it failed

You'll notice: Charge air temperature is misread, so the ECM can trim fuel and timing wrongly and the cold-start strategy may stay on.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 105 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.