EF Logo

Cummins · Aftertreatment - SPN 3251 FMI 4

Cummins Fault Code 1881

DPF differential pressure sensor signal voltage low

What does Cummins code 1881 mean?

The ECM sees the DPF differential pressure sensor signal below its normal voltage band. That points to a signal wire shorted to ground, a lost 5 V reference or a sensor that failed low. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: a reading below zero on the scale shows a low-voltage fault.

FaultCheck1881Cummins · Aftertreatment - SPN 3251 FMI 4

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: a reading below zero on the scale shows a low-voltage fault

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • DPF pressure sensor signal shorted to ground in the harness
  • Open reference wire at the sensor connector
  • Sensor failed low
  • Water in the connector

How it failed

You'll notice: The diesel particulate filter cannot be monitored properly.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: DPF pressure sensors and DPF system

1 other code on this part is also shorted low (3134). When they show together, start at the wiring and connector they share.

Show the other 11 codes
All 20 DPF pressure sensors and DPF system codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 1881 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 3251, FMI 4); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.