EF Logo

Cummins · Operator controls - SPN 91 FMI 3

Cummins Fault Code 131

Accelerator pedal position sensor signal voltage high

What does Cummins code 131 mean?

The ECM sees the accelerator pedal position sensor signal above its normal voltage band. Urgency: check soon - the machine may derate or limit a function. Check first: read pedal percent with the key on and the foot off; anything above zero at rest points to a high signal.

FaultCheck131Cummins · Operator controls - SPN 91 FMI 3

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read pedal percent with the key on and the foot off; anything above zero at rest points to a high signal

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Pedal signal wire rubbed bare at the firewall grommet and touching the reference line
  • Open return wire inside the pedal connector, so the signal rises to reference
  • Pedal track wiper worn and giving a stuck-high output
  • Footwell water corroding the pedal connector pins

How it failed

You'll notice: The pedal may do nothing, the engine may sit at a limited idle, or power is cut.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Accelerator pedal and remote throttle

3 other codes on this part are also shorted high (133, 1239, 1595). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 Accelerator pedal and remote throttle codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 131 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 91, FMI 3); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.